@Donald_Dump420

4:20 problem with those. Lol 420 blaze it but yeah. The female connector that goes into the serial port for that sp2sd2pro tend to be to thin. Can cause issues. Fix is through soldering lol. Get some pase flux and brush a little on with any brush preferably hard bristle/acid brush. Dont use a metal brush. And you see the 4 bars that make up the connector you gotta put a strip of sotter on each bar. The flux will help so much. Just get a small glob of solder on the tip of your pen and start from the top and quickly go down the bar. The bars look close together but its all good as long as you got flux because solder wont want to stick to plastic. Like metal. Had my solder iron at like 650 by the way. Also doesnt matter which side just pick one. If you make a pointy just take the sotter iron to it to melt away the pointy and even it out. This only if you have issues which i did

@pixelatedzephyr6325

i noticed 480i 120 in video modes does that mean 120hz?

@paulhouston4711

Hi,i got the mod kit,when i turn it on the gamecube logo appears then the game starts,at the point it should start swiss the console restarts back to the gamecube logo in a constant loop,any help would be appreciated.

@perdu6603

Can you use that setup to back your saves up with GCMM directly on the SD card inserted in the SD2SP2 or do you need some additional hardware?

@SkellyMan42069

How do games save? Do they still use memory card blocks or save files on the SD card itself? Cause I assume with the memory card and game exploit you need to have the game and mem card in always to boot the menu right?

@dalilserves

is your gamecube console  is pal

@dantiwolf

You need to put the disc in every time to boot Swiss?

@craggl0rd

I've got a Super Mario Sunshine exploit memory card on the way. I just want Swiss to force my physical games in 480p, do I still need SP2SD2 for this?

@tde439

So just a question. I have a Japanese GameCube so i need to use a Japanese game. Is the compatible game list the same for Japanese games?

@EMusic-SWest

OK but how do you get the Swiss on the card in the 1st place.. the Swiss disc I got, pal and ntsc do not read in the gc.. exact same disc you're showing too

@TheRealMrPeach

Swish???

@RyanCampbell21

Have you or anyone had issues with their audio? Im new to using a swiss booted GameCube and no matter what I've tried I cannot get audio from my games. I've tried new cables, re installing files, using a converter, not using a converter and even using a different TV/speaker. The volume is so low I can't hear it unless my tv is maxed out and even then the static is louder than the actual game. Everything else works perfect but I just can't get decent audio. Any suggestions?

@GrigorEftimov

HI- Did you modify your connection slot to be thicker?? I purchased sp2sd2 SD kit from you and my GameCube doesn't recognize the sp2sd2 SD Card, it just boots into a loop. Im using windwaker game with the provided memory card exploit etc.  Is there a solution  to this? Thanks