How to make a wireless water tank auto cut switch using rf transmitter and receiver module with 5v 10A relay module.

RF transmitter and receiver module with encoder and decoder ic for 433mhz radio module
Make sure you use same data lines on encoder and decoder
Float switch connection one wire connect on VCC and another wire connect on data pin D3 on transmitter
On receiver connect 5v relay module
VCC to VCC
GND to GND
Signal pin to data pin D3
Make sure you use 5v single channel relay module ( black)
(spdt) high-level trigger switch up to 10A at 250v ac.

Make sure you buy transmitter and receiver module and relay module from
Quartz components or makerbazar

**********************************

Please also watch my previous videos
Water tank auto cut switch
   • Water Pump Automatic Cut Of Switch | How T...  

RF transmitter and receiver module
   • RF Transmitter and Receiver With Encoder a...  

#rftransmitter #rfreceiver #relay #floatswitch #WATERPUMP #decoder #encoder #5vrelay

Thank you for watching my videos please subscribe my channel